Multitron - Incubation Shaker
Operation
Page 88 of 146 25 February 2019
One-time change from phase 1 to phase 2
If the equipment is programmed in this way, the two different para-
meter settings for the cultivating process change after the given
period of time. The equipment then runs using the settings for the
second phase until it is stopped manually by turning the parame-
ters off.
Application examples:
Delayed start of the cultivation process
Induction of a protein expression
Slow down or stop the cultivation process after the given time
period
To programme a one-time change from phase 1 to phase 2, the
timer for the second phase has to be switched off (Time 2 = off).
If the timer for the second phase is switched on (Time 2 = on),
there will be a cyclic change between the two phases (see the
To Next Page
Loading...