Inovance MD800 Series - Page 71

Parameter Group
-70-
Default:
1
Change:
At once
Value Range:
0: Disabled
1: Enabled
Description
This parameter defines whether to reset the communication fault automatically.
FD-07
Maximum station number auto allocated
Address:
64775
Min.:
0
Unit:
-
Max.: 8 Data type: UInt16
Default:
0
Change:
At once
Value Range:
0 to 8
Description
This parameter defines the maximum station number allocated automatically.
FD-09
CANopen/CANlink communication state
Address:
64777
Min.:
0
Unit:
-
Max.:
65535
Data type: UInt16
Default:
0
Change: Unchangeable
Value Range:
Ones: CANopen
0: Stop
1: Initializing
2: Pre-running
8: Running
Tens: CANlink
0: Stop
1: Initializing
2: Pre-running
8: Running
Description
This read-only parameter is used to monitor the communication status.
FD-10
Communication protocol
Address:
64778
Min.:
1
Unit:
-
Max.: 3 Data type: UInt16
Default:
1
Change:
At once
Value Range:
1: CANopen
2: CANlink
3: Communication card mode
Description
This parameter defines the CAN communication protocol.
When it is set to 1, CANopen communication is used. When it is set to 2, CANlink communication is
used. When it is set to 3, the communication card mode is used.