Chapter 4 Quick setup 59
(6) Set the IP address to an unused IP address belonging to the same network segment as
that of CPE1. For example, if the IP address of the CPE1 is 192.168.2.1, you can set this
device’s IP address to 192.168.2.X (X ranges from 2 to 254). Then set the Subnet Mask to
the same one of the CPE1, and click Next.
(7) Click Save, and wait until the device reboots to activate the settings.
2. Perform Step 1 to set CPE3 to Repeater mode, and bridge to CPE1.
3. Set CPE1 to Repeater mode and bridge to CPE2 and CPE3.
(1) Log in to the web UI of CPE1, and choose Quick Setup to enter the configuration page.
(2) Select Repeater mode, and click Next.
(3) Select SSIDs of CPE2 and CPE3, and click Next.
To Next Page
Loading...