JAC T9 - Closing of Filler Cap

94
Inspection and adjustment before driving
1. After adding fuel, close the fuel tank
cap tightly and rotate it clockwise until
3 "clicks" are heard.
2. Press the edge of the ller cap, and a
slight "click" can be heard to ensure that
the ller cap is closed.
Closing of ller cap
Warning
Warning
pollute the environment.
● The fuel splashed on the vehicle
must be removed in time to avoid
damage to wheel housing, tires and
vehicle body paint, etc.
● If the bioethanol fuel is used, its
relevant standards must be met to
avoid damage to the engine and the
fuel system.
● Replace the fuel tank cap only with
a new one from OEM. Unqualied
fuel tank caps can cause serious
faults and potential injuries.
● After adding fuel, please ensure that
the sealing ring of fuel tank cap and
the top of ller cap are clean.
● Before driving, make sure that the
ller cap is fully closed and locked.
Otherwise, the ller cap plate may
open unexpectedly during driving,
causing damage to the vehicle or
even casualties.
Notice
● When unscrewing the fuel tank cap,
if you hear a "hiss" of gas emission
(this is the sound from discharging
of oil vapor), wait for the sound to
stop and then unscrew the fuel tank
cap.
● If the ller cap is hard to be opened
due to freezing around ller cap
plate, tap to break the ice and then
try to open it again. If necessary,
spray qualied ice melting agent (do
not use radiator coolant) around the
ller cap plate or drive the vehicle to
a warm place to melt the ice.