Emergency
197
1
2
3
4
5
6
7
8
Trailer
After connecting the trailer according
to the manufacturer's instructions, it is
necessary to rst connect the trailer cable
before driving to ensure that the front car's
light control switch can control the trailer's
position lights, turn signals, rear fog lights,
reverse lights, and brake lights.
Instructions
1.Turn o the engine after applying
parking.
2.Connect the trailer and connect the
trailer harness electrical plug.
3.Place the ignition switch in the "ON"
position.
Notice
Notice
● After placing the ignition switch in
the "ON" position, the turn signal
and position light of the rear trailer
will light up for 3 seconds and then
turn o. The turn signal and position
light will automatically light up
for 3 seconds every ve minutes
to determine if the trailer power
is connected properly. This part
belongs to the system self-test and is
a normal phenomenon.
● Please ensure that the trailer lights
can be turned on while driving.
● At least one set of halogen lamps
should be ensured in the rear position
lights and turn signals, otherwise it
may be mistaken that the trailer is
not connected to the power supply.
● The auxiliary driving function will be
restricted after connecting the trailer.
After connecting the trailer, please
turn on the trailer mode according to
the pop-up instructions on the MP5
screen.
Vehicles can be equipped with
trailers at the rear. When towing a
trailer, the maximum speed should
not exceed 100km/h, and the rear
tire pressure should be increased
to 270kPa (standard tire pressure is
250kPa).
●
To Next Page
Loading...
