JAC T9 - Automatic Raising;Lowering; Anti-Pinching; Self-Learning of Window Function; Thermal Protection

72
Instruments and control
If your vehicle is equipped with the
automatic raising/lowering function of
four windows, it is not necessary to keep
pressing or pulling the window control
switch to fully raise or lower the window.
Automatic rising: pull up the control
switch quickly to Gear I and then release
it, and the window will automatically rise
to the top.
Automatic falling: press the control
switch quickly to Gear II and then release
it, and the window will automatically fall
to the bottom.
Stop automatic raising/lowering:
press or pull the corresponding window
switch again when raising or lowering the
window.
When the rising window is blocked, the
anti-pinching function will be activated
and the window will automatically fall to
the bottom.
Thermal protection may be triggered
to protect the window regulator after
repeated operation of the window control
switch. In this case, the window control
switch will temporarily fail to raise or
lower the window. The window switch can
automatically returns to normal working
state after the motor cools down.
If the battery is disconnected and
reconnected, the anti-pinching function
and automatic raising/lowering function of
window can be used normally only after
self-learning of the window function is
enabled through the following operations:
1.Turn the ignition switch to "ON"
position.
2.Lower the window to the bottom.
3.Pull up the control switch to raise the
window to the top, and keep pulling
up the control switch for more than 2 s
after the window rises to the top.
4.If the above actions are completed, it
Automatic raising/lowering
Anti-pinching
Thermal protection
Self-learning of window
function
Warning
● Never activate the anti-pinching
function intentionally by pinching
any part of your body.
● If an object is pinched when the
window is about to be fully closed,
the anti-pinching function may not
work.
indicates that the self-learning of driver
side window function is activated
successfully.
5.If the switch is released during window
movement, restart the above operation.
If the anti-pinching function and automatic
raising/lowering function of window still
cannot be used normally after self-learning
is completed, please contact an after-sales
service provider for support.