8
Safety
When the seat belt is pulled out quickly
from the retractor or the vehicle decelerates
quickly, the seat belt retractor will be
locked to prevent the seat belt from
sliding. In order to increase the reliability
of the seat belt, please check the working
condition of the seat belt. Grasp the
shoulder belt and pull it forward quickly.
The retractor shall be locked to prevent
the seat belt from further sliding. If the
retractor fails to hold the seat belt during
inspection, please contact the after-sales
service shop immediately for maintenance.
Check the working condition of
seat belt
Seat belt maintenance
Check all components of the seat belt (such
as buckle, latch, retractor, webbing and
anchor) for normal function on a regular
basis. If the seat belt webbing is found
loose, aged, cracked or otherwise damaged,
replace the entire seat belt set.
If dirt accumulates at the seat belt guiding
device, the retraction of the seat belt will
become slow. Please wipe the seat belt
guiding device clean with a clean dry cloth.
When cleaning the seat belt webbing,
please use neutral soap solution or the
recommended solution for interior trims or
carpet. Then wipe the seat belt with a cloth
and dry it in a cool place. Do not retract
the seat belt into the retractor before it is
completely dry.
Seat belt pretensioner system
If you vehicle is equipped with a seat
belt pretensioner system, the system may
start together with the airbag system, in
the event of certain collisions. The seat
belt pretensioner system works with
the seat belt retractor to help tighten the
seat belt immediately in the event of
certain collisions, thus protecting you and
passengers.
Seat belts equipped with pretensioner
systems are used in the same way as
normal seat belts.
To Next Page
Loading...
