JAC T9 - Switching of Drive Mode

121
Starting and driving
1
2
3
4
5
6
7
8
Switching of drive mode
Switch from "2H" to "4H"
Switch from "4H" to "2H"
Switch from "2H/4H" to "4L"
Switch from "4L" to "2H/4H"
Notice
● You can switch to 4WD mode after
several seconds after turning the
smart 4WD switch. There may be
a slight mechanical impact sound
during switching, which is normal.
● Do not turn the front wheels too far
during mode switching; otherwise,
mode switching may fail. When the
steering angle is too large, please
exit the 4WD mode; otherwise, tire
wear will be accelerated and the
vehicle may get out of control.
● Do not turn wheels too far when the
vehicle is in 4WD mode; otherwise,
shutdown due to excessive engine
load, abnormal tire wear and dicult
steering, etc. may occur.
● When the vehicle is running on a
normal road or highway, do not use
"4H" or "4L" drive mode; otherwise,
the following problems will occur:
(1)Generate noise;
(2)Aggravate tire wear;
(3)Increase fuel consumption and
damage the drive system.
Turn the 4WD mode knob to switch
among 2H, 4H and 4L modes. When a
certain mode is selected, the corresponding
indicator will ash. After switching is
completed, the indicator will stay on.
1.The speed is lower than 80 km/h when
the vehicle is stationary or running
straight.
2.Turn the smart switch from "2H" to
"4H".
3.When the indicator on the smart
switch stays on and the instrument
cluster displays "4H", the switching is
completed, with a maximum speed of 80
km/h.
1. The speed is lower than 80 km/h when
the vehicle is stationary or running
straight.
2. Turn the smart switch from "4H" to
"2H".
3. When the indicator on the smart
switch stays on and the instrument
1. Stop the vehicle to keep it stationary.
2. Place the gear shift in the neutral (N)
gear.
3. Turn the smart switch from "2H/4H" to
"4L".
4. When the indicator on the smart
switch stays on and the instrument
cluster displays "4L", the switching is
completed, and the vehicle can start
running with a maximum speed of 40
km/h.
1. Stop the vehicle to keep it stationary.
2. Place the gear shift in the neutral (N)
gear.
3. Fully depress the brake pedal for at least 5 s.
4. Turn the smart switch from "4L" to
"2H/4H".
5. When the indicator on the smart switch
stays on and the instrument cluster
displays "2H/4H", the switching is
completed and the vehicle can start
running.
cluster displays "2H", the switching is
completed.