JAC T9 - Driver Monitoring System (DMS)

169
Starting and driving
1
2
3
4
5
6
7
8
Warning
cannot be detected by the system or
is detected too late.
● The AEB system does not respond
to oncoming vehicles and vehicles
running laterally.
● Generally, the AEB system is usually
in the background working status
and it is not easy to be noticed by the
driver. Therefore, when a relevant
target is detected, it will not be
displayed for the driver.
● The implementation of the AEB
system requires the support of
electronic stability control system, so
ESC needs to be activated.
● The driver needs to ensure that the
seat belt is fastened and the doors are
closed; otherwise, the AEB system
will not function.
● With the AEB system activated, if
the driver quickly turns the steering
wheel or depresses the accelerator
pedal heavily, the AEB system will
exit.
Driver Monitoring System
(DMS)
When the vehicle is running, monitor the
driver's status during driving through the
driver monitoring camera installed on the
A-pillar. The system monitoring function
is activated when the vehicle is running
at a speed above 20 km/h and in forward
gear. If the driver has distracted, fatigued,
unresponsive, or other states that may
aect driving safety, the driver monitoring
system alerts the driver through instrument
display, text, and sound, reminding the
driver to focus. At the same time, the
system enhances the sensitivity of the
whole vehicle's intelligent safety functions,
such as forward collision warning and lane
departure warning, to avoid or reduce the
occurrence of trac accidents.
Warning
Warning
● Since the driver monitoring system
completes system initialization in
about 1 minute after vehicle startup,
the system will not work during this
period.
● The system function may be
degraded in some cases, such as
loss of monitoring data due to
strong sunlight or direct light on
the face, seat sitting posture, hair or
hat blocking eyes, etc. The system
uses an infrared camera, which may
be interfered by some sunglasses
with high shading rate, resulting in
performance degradation.
● In order to avoid the interference
of continuous alarm to the driver,
the system will not activate the
alarm again within 10s after the rst
reminder.
● Please make sure that the driver
monitoring camera is not covered or
blocked by other objects; otherwise,
the system cannot work normally.