JAC T9 - How to Use the Cruise Control

143
Starting and driving
1
2
3
4
5
6
7
8
Notice
● The current control speed displayed
by the cruise control system may be
dierent from the actual speed of the
vehicle.
● Performance of the cruise control
system on a slope depends on the
vehicle's speed, load and gradient.
When climbing a steep slope, you
may need to keep depressing the
accelerator pedal so as to keep the
speed. When going downhill, you
may need to brake to maintain the
speed. When stepping on the brake
pedal, the cruise will be canceled.
Warning
seat after CCS is activated.
● After the cruise control system
starts and you want to speed down
quickly, press the brake pedal as
usual.
How to use the cruise control
Turn on the cruise control system
Setting the cruise speed
Press the button on the steering wheel,
and the indicator (white) of the cruise
control system on the instrument will be
lightened and the cruise control system
will be turned on.
1. Accelerate to the needed speed (a speed
> 40 km/h).
2. Press , and the indicator of the
cruise control system on the instrument
will be green and the speed at this time
is the cruise speed.
Cruise deceleration
Any of the following methods can be used
for cruise deceleration:
● Press and hold , the vehicle will
gradually slow down and release when
reaching the desired speed.
● Press continuously, and the cruising
speed will decrease continuously in
units of 5.0km/h.
● Slowly step on the brake pedal, and
the indicator of the cruise on the
instrument will turn white. After the
vehicle decelerates to the needed speed,
press , and a new speed can be set
and the indicator on the instrument
will turn green again.
3. Release the accelerator pedal, and the
vehicle will keep driving at the set
speed.