JAC T9 - Engine Oil; Replacement of Engine Coolant; Checking the Engine Oil Level

Maintenance and do-it-yourself
220
Replacement of engine coolant
The expansion tank for the engine coolant
is located on the left side of the engine
compartment. Refer to the gure above for
specic location. When the engine is fully
cooled, the coolant level should be between
the "F" and "L" scale lines. If it is below
the "L" scale line, add coolant as soon as
possible.
The steps for adding engine coolant are as
follows:
1. Conrm that the engine and radiator
have completely cooled.
2. Slowly unscrew the lid of the expansion
tank.
3. Fill the expansion tank with engine
coolant until it is near the "L" scale line.
4. Tighten the lid of the expansion tank.
Engine coolant needs to be replaced
regularly. For specic replacement
intervals, see the Warranty and
Maintenance Manual. If engine coolant
needs to be replaced, please refer it to an
after-sales service shop for operation. Do
not replace it yourself.
Engine oil
Checking the engine oil level
1. Park the vehicle on a at surface and
apply the parking brake.
2. Start the engine and warm it up until
the engine temperature reaches normal
operating temperature (approximately 5
min).
3. Shut down the engine.
4. Wait at least 10 min for the engine oil to
return to the oil pan.
5. Take out the oil dipstick and wipe it
clean.
6. Insert the oil dipstick completely.
7. Take out the oil dipstick again and
check oil level. It should be between the
two marked points "MAX" and "MIN"
on the oil dipstick.
7. Take out the oil gauge and check the oil
level. The oil level should be between
the two mark points (MAX and MIN)
of the oil gauge.