JAC T9 - Tire Rotation; Tire Wear and Damage

Maintenance and do-it-yourself
237
1
2
3
4
5
6
7
8
Tire rotation should be performed every
8,000 km to 13,000 km. Once abnormal
tire wear is found, carry out tire rotation
and check wheel alignment as soon as
possible.
Check the tire dynamic balance during tire
rotation.
Check whether the tire is abnormally
worn and whether the tire and wheel are
damaged during tire rotation. Abnormal
wear is usually caused by incorrect
tire ination pressure, improper wheel
alignment, poor wheel balance, emergency
brake or sharp turn. Check the tread or tire
side for protrusions or bumps, and replace
the tire if one of these conditions is found.
The purpose of regular tire rotation is
to make all the tires of the vehicle wear
evenly. When carrying out tire rotation,
be sure to follow the correct tire rotation
mode in the gure below.
Tire rotation
Warning
● After wheel changing, ensure that all
wheel nuts are properly fastened.
● After wheel changing, be sure to
check and adjust the tire pressure.
● Improper tire selection, installation,
or maintenance can aect the vehicle
safety, resulting in accidents and
injuries. If you have any questions,
please consult the after-sales service
shop or tire manufacturer.
Tire wear and damage
①
Wear mark
②
Location of wear mark
When the tread is worn to 2 mm, the
tire must be replaced to help prevent the
vehicle from sideslipping. When the tread
is worn to 2 mm, the built-in tread wear
indicator or tread wear indicator will
appear on the tire.
When the tread wears to the same height as
these indicators, the tire has worn out and
must be replaced.
Regularly check the tread and sidewall
for damage (such as bulges on the tread