Emergency
186
Hazard warning device
Hazard warning asher
There is a triangle mark on the hazard
warning lamp switch, as shown in the
picture.
Unless the battery is completely
discharged, the hazard warning asher
can operate regardless of the start switch
position.
Press down the hazard warning asher
switch and then all turn signal lamps
will ash. To turn o the hazard warning
asher, and press down the hazard warning
Warning triangle
The warning triangle is stored in the red
packaging box, and placed below the side
seat of the front-row passenger.
Encountering unexpected faults on the
road, and parking for maintenance, or
when accident occurs, the vehicle fails
to be moved to a safe area, the hazard
warning asher shall be turned on, and
a warning triangle shall be placed in the
direction of the incoming trac. The
retroreective performance of the warning
asher switch again.
The hazard warning asher shall be
enabled to warn other drivers under the
following circumstances:
(1)An emergency or dangerous situation
occurs.
(2)Vehicle is in an unsafe state due to a
malfunction.
(3)Drive the vehicle in rainy, snowy, foggy
or low visibility conditions.
(4)Your vehicle has to be parked in an
unsafe parking area for some reason.
Notice
● When the hazard warning asher is
turned on, turning on the turn signal
lamp will give priority to sending
a turn or lane change signal. After
turning o the turn signal lamp, the
hazard warning asher will continue
ashing.
● If not necessary, do not turn on the
hazard warning asher for a long
time when the engine is shut down to
avoid battery depletion.
A/C
OFF
To Next Page
Loading...
