6
Safety
Checking of seat belt
Do not use twisted seat belts.
Keep the seat belt clean and check the
conditions of all seat belts regularly. If it is
dicult to pull the seat belt out of the seat
belt guiding device, the reason may be that
the seat belt returns to the side trim too fast,
causing the seat belt to become twisted.
1. Hold the seat belt latch, and then pull the
seat belt out slowly.
2. Smooth the seat belt by hand, and then
slowly release to put it back to the side
trim panel.
Three-point seat belt
Fastening of seat belt
The seat belt can be fastened according to
the following steps:
1.Adjust the seat to a proper position.
2.Pull out the seat belt slowly to ensure
that it smoothly bypasses the entire
pelvis, chest and mid-clavicular point
and remains between the neck and the
shoulder.
3.Insert the seat belt latch into the buckle
and press it until a "click" is heard.
4.Pull the seat belt hard to check whether it
is fastened properly.
Warning
● Never excessively incline the
backrest for comfort. Seat belts work
best when passengers sit upright on
the seat against the backrest.
Notice
● The seat belt retractor will lock the
seat belt in case of sudden braking or
collision. Pull the seat belt slowly to
allow it to stretch slowly.
● If the seat belt cannot be pulled out
from the fully retracted position, pull
the seat belt hard and then release it,
and then pull the seat belt out of the
retractor smoothly.
To Next Page
Loading...
