56
Instruments and control
Light adjustment
The adjustment switch for the exterior
headlights is located on the lower side of
the dashboard near the driver's door.
When the ignition switch is in the "ON"
position and the headlights are turned
on, the driver can adjust the angle of the
headlamp axis through the headlamp
height adjustment knob.
● Turn the knob upwards to raise the
headlamp beam;
● Turn the knob downwards to lower the
headlamp beam.
Adjust the headlamp beam to the
appropriate position based on the vehicle
Removal
Installation
1.Pull the headrest up to the highest
position.
2.Press the locking button.
3.Continue to pull the headrest upwards
and remove it from the seat. (The ceiling
1. Align the headrest lever with the hole
on the seat. Ensure that the headrest
is facing the correct direction. The
headrest lever with an adjustment slot
must be installed in the hole with a
locking button.
2. Press and hold the locking button
and press the headrest down to the
appropriate position.
Use the following steps to remove the
headrest.
Use the following steps to install the
headrest.
Always select the use position when riding
in the vehicle.
When selecting the use position, move the
headrest to the securely locked position in
which a clicking sound can be heard. When
selecting the storage position, push the lock
button while pushing the headrest down.
space is small, and the headrest may not
be able to be removed. At this time, you
can unlock the backrest and rotate the
seat before removing the headrest.)
To Next Page
Loading...
