83
Inspection and adjustment before driving
1
2
3
4
5
6
7
8
Notice
● Even if the smart key is within the
eective operating range, the smart
key system may not be able to
work normally under the following
conditions:
(1)The smart key is left in the
vehicle.
(2)The smart key battery runs out.
(3)The ignition switch is at "ON"
position.
(4)When unlocking or locking the
doors, the smart key is too close
to the window, door handle or
the ground, or is placed at a high
place.
(5)When there are strong radio waves
near the vehicle, the eective
operating range of the smart key
system will become smaller or
even the smart key system cannot
work normally.
Remote control of window
O
Alarm
On
All doors are closed. Press and hold the
LOCK button on the key within the
eective range, and the four windows will
rise automatically. And all doors of the
vehicle will be locked. At this time, the
turn signal will ash once and the horn will
sound once to indicate that the vehicle is
locked.
The vehicle will give an alarm when the
following conditions occur during remote
control closing of window:
1. Anti-pinching function of any window is
enabled.
2. Any window fails to rise to the top.
3. Self-learning of anti-pinching function
and one-button regulating function of
windows is not completed.
All doors are closed. Press and hold the
UNLOCK button on the key within the
eective range, and the four windows will
fall automatically. And all doors of the
vehicle will be unlocked. At this time, the
turn signal will ash twice to indicate that
the vehicle is unlocked.
Notice
● Press and hold the button for more
than 2 s.
● The window can be stopped by
pressing any button on the smart key
during remote control.
● When the ignition switch is at
"ACC" and "ON" positions, the
remote control of window cannot be
used.
● If the remote control of window is
used repeatedly in a short time, it
may fail due to protection of motor
service life. At this time, wait for
a while (generally for about 20 s)
before using the remote control of
window again.