JAC T9 - Adblue Filler

95
Inspection and adjustment before driving
1
2
3
4
5
6
7
8
2. Rotate the AdBlue ller cap (blue)
counterclockwise to add AdBlue.
3. When the lling is completed, put the
AdBlue cap back and rotate it clockwise
until a “click” sound is heard, indicating
that the AdBlue ller cap is installed in
place.
4. Close the fuel ller cap.
Filling can be carried out in two ways, and
manual lling is recommended.
①
Use a special AdBlue lling gun;
②
Fill manually.
If your vehicle is a diesel vehicle with
high emission requirements (Euro VI), it is
necessary to ll the AdBlue.
When the SCR indicator illuminates on
the dashboard, you should immediately
add the AdBlue for automobiles that meets
the requirements according to the textual
reminder displayed on the instrument.
Do not let the vehicle lack AdBlue or use
unqualied AdBlue; otherwise, there will
be vehicle speed limit and engine torque
limit, which will shorten the service life of
the engine and after-treatment device.
The AdBlue ller is beside the fuel ller.
Please add AdBlue according to the
following steps:
1. The ller cap plate is located at the rear
left side wall panel of the vehicle. You
can open the ller cap plate by slightly
pulling the ller cap plate opening
handle at the front lower part of the
driver seat.
Notice
● Adding AdBlue can reduce emission.
Before using the vehicle, please ll
standard AdBlue according to local
laws and regulations.
● When lling AdBlue, it is necessary
to avoid impurities from entering
and use a special pipe. If impurities
are brought into the tank, it will
cause blockage. To prevent entry of
impurities, always use pure water
when cleaning AdBlue-related
accessories. Tap water is not allowed.
AdBlue is alkaline, which has great
AdBlue ller