JAC T9 - Engage P Gear; Engage D;R;N Gear; Engage M Gear

117
Starting and driving
1
2
3
4
5
6
7
8
Engage P gear
Engage D/R/N gear
Engage M gear
When the vehicle is stationary, press P gear
button
②
.
Depress the brake pedal and press the
UNLOCK button
③
, and the vehicle shifts
from gear P to other gear.
Push the gear shift in the required
direction for a short time. If necessary,
push it to exceed the pressure point. It can
automatically return to the middle position
after being released.
The gear can be adjusted manually when
M gear is engaged.
Taking the gear lever of a left-hand drive
vehicle as an example: after shifting to D
gear, pull the gear shift left to switch to M
gear, push it forward to upshift manually
and pull it backward to downshift
manually. Pull the gear shift right again to
shift to D gear.
①
Gear shift
②
Pgear button
③
UNLOCK button
Notice
Notice
● The vehicle will automatically shift
to P gear in the following conditions:
(1)The vehicle is stationary and
the START switch is switched to
LOCK mode.
(2)The vehicle is stationary, the
driver seat belt is not fastened, the
accelerator pedal and the brake
pedal is not depressed and the
driver side door is open.
● When the driver's door is opened
and the seat belt is fastened, it is
permissible to shift out of P gear.
When the driver's door is opened
and the seat belt is not fastened, the
vehicle cannot be shifted out of P
gear.
● After the gearshift operation is
completed, conrm that the correct
gear has been engaged according to
the instrument cluster display.
● Depress the brake pedal and pull the
gear shift backward to engage D gear;
● Depress the brake pedal, press the
UNLOCK button
③
and push the gear
shift forward to engage R gear;
● Depress the brake pedal and place the
gear shift in the middle position to engage
N gear.
(Right rudder)