JAC T9 - Blind Spot Detection (BSD)

160
Starting and driving
Blind Spot Detection (BSD)
The blind spot detection system monitors
the blind spot in the driver's view through
two rear millimeter-wave radars.
When the vehicle appears in this area
and the warning conditions are met, a
warning light on the corresponding exterior
rearview mirror will alert an approaching
vehicle behind the vehicle. Please do not
change lanes to avoid collisions.
When the vehicle speed is not less than 20
km/h, the blind spot detection system will
be activated.
Warning
Warning
● Failure to comply with warnings and
instructions regarding the proper use
of the blind spot detection system
may result in serious injuries or
accidents.
● Radar sensors cannot detect all
vehicles under any circumstances,
and careless and unsupervised use of
the system may lead to accidents and
serious injuries. The system cannot
replace the driver's attention.
● If the vehicle coming from behind is
too fast, the system display will not
react in time!
● The blind spot detection system
cannot replace correct driving
behavior, nor is it designed to avoid
contact with vehicles or objects.
When changing lanes, always use the
exterior rearview mirrors to observe
the direction for lane changing to
ensure safe lane changing. Do not
rely solely on the blind spot detection
system.
● When you are driving on a curve,
if the curve radius is too small, the
system will not be able to give a
normal warning!
● The visibility of radar sensors may
be reduced due to rain, snow, and
violent splashes of water, which may
cause the system to fail to recognize
the vehicle in time or even fail to
recognize the vehicle! Please always
maintain direction and observe the
surrounding environment.
● The blind spot detection system
the rear axle dierential lock indicator
(yellow) on the instrument ashes for a
few seconds and then goes out, it indicates
that locking fails.
Overspeed alarm
When driving with the rear axle dierential
lock locked, if the indicator on the button
ashes and the indicator (green) on
the instrument ashes, it indicates that
the vehicle speed is too high. Please slow
down.
Overspeed automatic unlocking
When driving with the rear axle dierential
lock locked, if the vehicle speed exceeds
40 km/h, the rear axle dierential lock will
be unlocked automatically.
Fault alarm
When the dierential lock system fails,
the rear axle dierential lock indicator
(yellow) on the instrument will be
normally on. After the vehicle is powered
on, there will be an alarm sound. In this
case, go to the after-sales service store for
inspection.