JAC T9 - Page 169

161
Starting and driving
1
2
3
4
5
6
7
8
Warning
cannot guarantee 100% detection
of conventional vehicles within the
blind spot (such as sedans, trucks,
low-power motorcycles, electric
vehicles, or bicycles), so drivers still
need to drive and judge carefully to
avoid danger!
● When the rear radar is subjected to
strong vibration or impact, or the rear
bumper is deformed due to impact,
the calibration of the rear radar
will be aected, thereby reducing
system performance. At this point,
it is necessary to contact the after-
sales service store for professional
inspection and calibration.
The blind spot detection system helps the
driver understand the trac conditions
in the blind spots of the exterior rearview
mirrors and behind the vehicle with radar
sensors; during lane changing, the system
reminds the driver through the display
indicators on the left and right exterior
rearview mirror lenses.
Standard display mode: When the system
detects that there are other vehicles in the
rear blind spot and that lane changing will
be dangerous, the indicator will remain on.
Notice
● To avoid aecting the system
function, there should be no foreign
objects obstructing the radar sensor
area on the rear bumper (such as
labels and bike racks).
● When there is a vehicle towed, the
blind spot detection system will not
work properly. Please make sure to
deactivate the system.
● The display area on the exterior
rearview mirror lenses must not be
obscured by labels.
● The rear radars are installed on both
sides of the vehicle's rear bumper,
and there should be no obstacles in
the eld of view of the radar sensors.
To ensure the normal operation of
the system, there should be no snow
or ice accumulation in the bumper
radar sensor area.
Display mode