JAC T9 - Wiper and Washer Switch

57
Instruments and control
1
2
3
4
5
6
7
8
Wiper and washer switch
Warning
Warning
● If the headlights are set too high or
the high beams are not used properly,
it may have a dazzling eect on
drivers of other vehicles on the road,
distract their attention, and easily
lead to serious injury and death
accidents.
● Make sure to adjust the front
headlights correctly so that they are
always in a suitable lighting state.
● If it may dazzle other vehicle drivers,
do not activate the high beam or
ashing function of the headlights.
● Please observe local laws and
regulations when using headlights.
● When the temperature drops near the
freezing point, and no appropriate
antifreeze measures are taken, the
detergent may freeze on the front
windshield and hinder your line of
sight. Before using a windshield
washer to clean the windshield, you
must rst use the front windshield
heating function to heat the front
windshield. Otherwise, the detergent
can freeze on the glass and block the
driver's line of sight.
● Worn or dirty wiper blades will
greatly reduce the visibility in front
and the driving safety. Damaged or
worn wiper blades must be replaced
in time.
● Do not use the windshield washer
continuously for more than 15
seconds or use the windshield washer
when there is no washer uid in the
washer uid reservoir; otherwise, the
windshield washer motor is likely to
be burned.
load and driving conditions to improve
visibility without dazzling oncoming
vehicles.
Notice
● Do not use the wiper when the glass
is dry. Otherwise, the wiper blade
may be worn quickly.
● When the temperature drops to near
freezing point, check whether the
wiper blade is frozen on the front
windshield before driving. In cold
weather conditions, when parking
for a long time, lift the wiper away
from the front windshield.
● Before driving, clean the snow, ice,
leaves and other debris on the front
windshield.
● It is recommended to deactivate
the wiper before parking. Turn the
ignition switch to the OFF position
when the wiper is activated. When
the vehicle is started again, the wiper
will continue to wipe according to
the previous settings. At this time, if
there is ice, snow or other adhesive
on the windshield, the wiper motor
may be damaged.