JAC T9 - Replacement of Bulb

Maintenance and do-it-yourself
233
1
2
3
4
5
6
7
8
5. Use a fuse extractor to remove the
damaged fuses. The fuse extractor is in
the engine compartment fuse box cover.
6. Install new fuses with the same rated
current.
Regularly check the operation conditions
of the exterior lights. Damaged bulbs will
reduce the vehicle visibility and weaken
its capability to send warning signals to
other drivers, posing a serious threat to
driving safety.
The replacement of bulbs requires a
certain amount of professional knowledge.
Improper replacement of bulbs may cause
accidents and severe injury. It is highly
recommended that you go to an after-sale
shop for the replacement of bulbs.
When replacing a bulb, if it is necessary
to remove other components around it or
replace the non-halogen bulb, it must be
replaced by the after-sales service shop.
Replacement of bulb
Warning
● In order to avoid sudden vehicle
movement, burning your ngers
with bulbs, or a motor re, before
replacing the bulb, rmly apply the
parking brake, switch the start switch
to the "OFF" or "LOCK" position,
and turn o the light until the bulb
heat dissipates.
● Be sure to replace the burnt-out bulb
with a new one of the same value;
otherwise, the fuse or circuit system
will be damaged.
● The high-pressure halogen gas is
enclosed inside the halogen bulb. If
the glass cover is scratched or the
bulb falls, the bulb will break.
● When holding the bulb, only touch
the lamp holder, never touch the
glass. Touching the glass cover can
seriously aect the service life of
the bulb and the performance of the
headlights.
● In the process of bulb replacement,