119
Starting and driving
1
2
3
4
5
6
7
8
Start driving
Parking
Method II
1. Fasten the seat belt and conrm that the
parking brake has been applied.
2. Start the engine.
3. After the engine speed is stable, engage
D gear (it is recommended to engage
M gear when a large output torque is
required for hill start).
4. Release the brake pedal and then gently
depress the accelerator pedal to make the
vehicle accelerate.
1. Release the accelerator pedal, and
depress the brake pedal.
2. After the vehicle stops stably, press P
gear.
3. Apply the parking brake as required or
stop the engine directly.
4. Release the brake pedal.
1. Stop the engine and apply the parking
brake.
2. Enter the bottom of the vehicle.
3. Use a 6 mm Allen wrench to screw
the "P-disengaging bolt" clockwise
to the end. At this time, the
"P-disengaging rocker arm" is jacked
up by the "P-disengaging bolt", and
the transmission enters unlocking state
of P gear. At this time, if the vehicle is
powered on or started, an alarm sound
will be given. The instrument displays
"Transmission P Gear Fault" and the
transmission is in N gear.
4. Then, use a 6mm Allen wrench
to turn the "P-disengaging bolt"
counterclockwise until the bolt is just
separated from the "P-disengaging
rocker arm", and then P gear can be
restored.
Warning
● After the P-disengaging bolt is used,
it needs to be replaced with a new
one.
P-disengaging
rocker arm
P-disengaging
bolt
To Next Page
Loading...
