147
Starting and driving
1
2
3
4
5
6
7
8
(1)When the engine runs over 20 s, press
the DPF regeneration switch for over
3 s, and the regeneration system will
automatically start.
(2)During the activating of the
regeneration system, the engine speed
will increase to 1500 - 2200 rpm, and
a regeneration period is about 15 - 20
min.
(3)After the regeneration, the DPF
indicator will go out automatically,
and the engine can be turned o after
the engine return to the idle speed after
2 - 3 minutes.
Activating parking regeneration
3. Service regeneration
If the DPF indicator is still ashing
or on after two parking regeneration
operations, the DPF system should go
through check and repair in the after-sales
service store.
Notice
● If the DPF indicator still ashes
after the regeneration, we suggest
you perform the parking regeneration
operations again.
● If the engine idle speed remains
high after regeneration (950-
1000rpm, normal vehicle idle speed
is about 700rpm), it indicates that
the regeneration process has not
been completed. It is recommended
to initiate a parking regeneration
operation again.
● If it must be stopped in case of
emergencies, just press DPF
regeneration for over 3 s.
Warning
● The company will not be responsible
for any environmental protection
issue and damage arising from the
failure to perform as required above.
To Next Page
Loading...
