JAC T9 - Page 164

156
Starting and driving
Warning Warning
if the target vehicle ahead starts and
accelerates after a long time, the
driver needs to slightly depress the
accelerator pedal or press the on
the left side of the steering wheel to
conrm following the vehicle ahead
based on the road conditions.
● The ACC system is unable to detect
protrusions loaded on the target
vehicle ahead (such as rear towing,
side protrusions, items loaded on
the roof, or installed accessories).
When driving in adjacent lanes of
such vehicles, be sure to deactivate
the ACC system, and actively apply
brakes according to the actual
situation.
● When the vehicle with ACC system
activated is running on a road
surface with metal objects such as
steel plates for road repair, railway
rails, and protruding metal manhole
covers, the front millimeter-wave
radar may be interfered with and
unable to work properly, resulting in
ACC reaction errors.
● Do not use the ACC system when
towing other vehicles.
● To ensure safety, do not use the ACC
system when driving on roads with
poor visibility, along sloping roads,
winding mountain roads, or on wet
and slippery sections (such as snow,
water, or ice).
● The driver must be ready to take over
the vehicle at all times and control it
through acceleration or braking.
● When the ACC system requests the
driver to take over, the driver should
immediately take over the vehicle,
conrm the distance from the vehicle
ahead, and apply brake to ensure
safety.
● The front millimeter-wave radar is
located in the middle of the lower
grille of the front bumper. Please
do not block it or stick foreign
objects on it, as this may cause a
Warning
by electromagnetic interference,
resulting in delay or interference.
● The eld of view of the front
millimeter-wave radar cannot be
obstructed by pollutants. When it is
completely covered with snow or
ice, the ACC system will exit, and
the system exit information will be
transmitted to the driver through the
instrument cluster.
● The calibration of front millimeter-
wave radar may be aected by
vibrations or collisions, resulting in
compromised performance. In this
case, the radar needs to be rechecked
or recalibrated.
● When the target vehicle ahead brakes
and stops, the vehicle with the ACC
system activated will slow down
and stop accordingly. If the target
vehicle ahead starts and accelerates
in a short period of time, the vehicle
with the ACC system activated will
automatically follow and accelerate
(not exceeding the set cruise speed);