JAC T9 - Page 199

Emergency
191
1
2
3
4
5
6
7
8
3. Locate the jacking point of the vehicle
jack, as shown in the gure.
4. Place the jack on a at and hard ground,
and adjust the jack position so that it
is aligned directly below the vehicle
jacking point, while the top of the jack
contacts the jacking point.
5. The cranking bar
⑦
of the combined
crank used for removal of spare tire is
caused to clamp the handle of the jack.
6. Turn the jack handle in clockwise
direction and carefully raise the vehicle
until a desired gap exists between the
tire and the ground. Can the wheel nuts
be completely removed only after the
tire is o the ground.
7. Remove the damaged tire for
replacement with spare tire.
Front
support point
Rear
support point
Warning
● Be sure to read and follow the
operating instructions in this chapter.
● Do not get under a vehicle supported
by a jack.
● Do not use a jack not equipped with
this vehicle.
● The jack equipped on the vehicle is
only used to lift the vehicle during
tire replacement.
● Do not lift the vehicle other than the
specied jacking point.
● Do not lift the vehicle where
unnecessary.