43
Instruments and control
1
2
3
4
5
6
7
8
Warning
● The maximum driving speed shall be
based on the specic road conditions
and local laws and regulations.
Never overspeed.
14. Overspeed warning light (red)
15. AUTO HOLD fault warning light
(red)
16. Fuel lter water level indicator
(red)
17. Engine fault indicator (yellow)
18. Air lter blocking indicator
(green)
When the vehicle's driving
speed exceeds the set
overspeed warning speed,
the overspeed warning light
will light up, indicating that the vehicle has
exceeded the warning speed. At this time,
reduce the vehicle speed immediately.
When the ignition switch
is in the "ON" position, the
system rst performs a self-
check. The tire pressure
monitoring system fault warning light
lights up for a few seconds and then goes
out, indicating that the system is in normal
working condition.
When the water in the oil-
water separator reaches a
dangerous level, the fuel
lter water level indicator
will light up. If the indicator is still on
when the engine is running, it indicates
that the water in the oil-water separator
shall be drained.
This indicator is a part of
the in-vehicle diagnosis
system, which can monitor
the malfunction of the
vehicle engine. When the ignition switch
is in the “ON” position, the indicator will
light up until the engine is started.
When the air lter is
blocked, this indicator will
light up.
Stop the vehicle
immediately to check if the air lter is
blocked. Otherwise, the engine may be
damaged.
120
If this warning light continues to light up,
or lights up during driving, or does not
light up when the ignition switch is in the
"ON" position, it indicates a malfunction
in the AUTO HOLD system. At this point,
contact an after-sales service store as soon
as possible for maintenance.
If this indicator lights up when driving
or goes out when the ignition switch is in
the "ON" position, contact an after-sales
service store for inspection as soon as
possible.
To Next Page
Loading...
