3ļ¼58
JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.6 DISPLAY USER MAP
The cursor mode changes to the normal operation mode, terminating the user map
insertion/correction mode.
(Example)
3.6.3.6 Deleting a mark or vertex from a line (Delete Vertex)
With regard to the created user map, a vertex is deleted individually from a mark or line.
Procedures
1) Open the Edit User Map menu by performing the following menu
operation.
āć
The Edit User Map menu will appear.
2) Left-click the button.
The user map delete mode is selected.
is displayed in the cursor mode located at the upper right of the radar display.
3) Put the cursor on the vertex of a mark or line, and left-click.
The selected mark or vertex of the line is deleted.
All of the lines drawn by joining two points are deleted.
To delete another mark or vertex of a line, repeat procedure 3.
4) When finished with the correction of all items, left-click the
button.
Original vertex
New vertex
U.Map
2. Edit User Map
6. Delete Vertex
Delete
0.Exit
To Next Page
Loading...
Need help?
General
