Juniper EX4300 Series User Manual

4.
a. 48-port EX4300 switches except EX4300-48MP and EX4300-48MP-S switches—Hold both the
ejector handles or the capve screws on the uplink module and gently pull the uplink module
toward you and out of the module slot.
b. EX4300-48MP and EX4300-48MP-S switches—Hold the ejector handle on the uplink module and
gently pull the uplink module toward you and out of the module slot.
5. Place the uplink module in an anstac bag or on an anstac mat placed on a at, stable surface.
6. If you are not replacing the uplink module, install the cover panel over the slot.
NOTE: Aer you have removed an uplink module, wait for at least 5 seconds before you
install an uplink module. If you do not wait for at least 5 seconds, the interfaces on the uplink
module might not come up.
Figure 92: Removing a 4-Port 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ Uplink Module from a 24-
Port or 48-Port EX4300 Switch Except EX4300-48MP and EX4300-48MP-S Switches
305

Juniper EX4300 Series Specifications

General

Brand	Juniper
Model	EX4300 Series
Category	Switch
Language	English