This topic describes the EMC requirements for these hardware devices.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
The Industry Canada label idenes cered equipment. This cercaon means that the equipment
meets certain telecommunicaons network protecve, operaonal, and safety requirements. Industry
Canada does not guarantee the equipment will operate to the users’ sasfacon.
Before installing this equipment, users should ensure that it is permissible to connect the equipment to
the facilies of the local telecommunicaons company. The equipment must also be installed using an
acceptable method of connecon. In some cases, the inside wiring associated with a single line
individual service can be extended by means of a cered connector assembly. The customer should be
aware that compliance with the above condions might not prevent degradaon of service in some
situaons.
Repairs to cered equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alteraons made by the user to this equipment, or equipment
malfuncons, might give the telecommunicaons company cause to request the user to disconnect the
equipment.
CAUTION: Users should not aempt to make electrical ground connecons by
themselves, but should contact the appropriate inspecon authority or an electrician, as
appropriate.
Users should ensure for their own protecon that the electrical ground connecons of the power ulity,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precauon might be parcularly important in rural areas.
Taiwan
此為甲類資訊技術設備。於一般家居環境使用時，本設備可能導致射頻干擾，用戶請採取相應措施。
The preceding translates as follows:
This is a Class A device. In a domesc environment, this device might cause radio interference, in which
case the user needs to take adequate measures.
398
To Next Page
Loading...
Need help?
General
