3. Remove the power distribution
module.
Remove the four T30 fixing
screws on the edges of the
module's front panel.
The module moves on its rollers
on the rack. Use the handle to
carefully pull out the module.
NOTICE
Protect the components that
are installed back into the unit
from dirt.
4. Remove the control module.
NOTE
Before you detach wires,
cables, or connectors, take a
photograph of them.
Detach all cables or
wires connected to the
control module's front panel.
Remove the four T30 fixing
screws on the edges of the
module's front panel.
The module moves on its rollers
on the rack. Use the handle to
carefully pull out the module.
NOTICE
Protect the components that
are installed back into the unit
from dirt.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 108 REV 2.40 EN 04-2024
To Next Page
Loading...
