2. Assemble the steel base. Use
two M6 bolts for each seam to
attach the panels together.
3. Use fasteners to install the steel
base to the installation surface.
NOTE
The fasteners used for
installing the steel base to the
installation surface are not
included in the delivery.
4. Lift the charging power unit
onto the steel base. For moving
and lifting instructions, see 5.1.3:
Moving and lifting Power Unit.
Make sure that the unit is
horizontally level.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 45 REV 2.40 EN 04-2024
To Next Page
Loading...
