2. Drill the fixing holes (1): 350 x 350
mm.
3. Open the Control Unit door and
align the unit with the fixing
holes.
4. Install the fixing screws into
place. Make sure that the
installation level is horizontal.
If necessary, use appropriate
washers.
NOTICE
6 mm fixing screws
are recommended for wall-
mounted installations. Use 8
mm fixing screws for more
challenging installations.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 75 REV 2.40 EN 04-2024
To Next Page
Loading...
