KEMPOWER Power Unit - Page 81

5. Route the charging cable into
the unit. Make sure that the
wires reach the terminals.
Tighten the cable bushing.
6. Connect the charging cable
wires to the terminals.
Tighten each screw terminal to
the correct torque.
•
6–25 mm
2
: 12 Nm
• 35–95 mm
2
: 22 Nm
NOTICE
Do not exceed the bending
radius of the cable given by
the cable manufacturer.
7. Route the supply cable into the
unit and connect the wires to
the terminals.
Tighten each screw terminal to
the correct torque.
•
6–25 mm
2
: 12 Nm
• 35–95 mm
2
: 22 Nm
NOTICE
Do not exceed the bending
radius of the cable given by
the cable manufacturer.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 76 REV 2.40 EN 04-2024