8. Route the control cable into the
unit and connect the wires to
the terminals.
NOTICE
Do not exceed the bending
radius of the cable given by
the cable manufacturer.
9. Close the Control Unit door.
10. Connect the AC power supply to
the unit from the main supply
point (3).
In each cabinet, set the
miniature circuit breaker (MCB)
for control voltage (2) and main
switch (1) to ON position.
Lock the door(s) of the unit.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 77 REV 2.40 EN 04-2024
To Next Page
Loading...
