Keysight EDU33210 Series - Width or Duty Cycle Deviation

Front Panel Operations
1. Press [Waveform] > Pulse.
2. Press [Modulate] > Type PWM > PWM Freq.
Use the numeric keypad or the knob and arrows to set a desired value. If you use the keypad, select a prefix unit to
finish.
SCPI Command
[SOURce[1|2]:]PWM:INTernal:FREQuency {<frequency>|MINimum|MAXimum|DEFault}
Width or Duty Cycle Deviation
The PWM deviation setting is the peak variation in width of the modulated pulse waveform. You can set it in units of
time or duty cycle.
Front Panel Operations
1. Press [Waveform] > Pulse.
2. Press [Modulate] > Type PWM > PWM Dev. Use the numeric keypad or the knob and arrows to set a desired value. If
you use the keypad, select a prefix unit to finish.
To set deviation in terms of duty cycle:
1. Press [Units] >Width Duty Cyc > Width Duty Cyc.
2. Press [Modulate] > Duty Cycle. Use the numeric keypad or the knob and arrows to set a desired value. If you use the
keypad, press Percent to finish.
SCPI Command
[SOURce[1|2]:]PWM:DEViation {<deviation>|MINimum|MAXimum|DEFault}
Keysight EDU33210 Series User's Guide
115