Keysight EDU33210 Series - Trigger out Signal

To specify whether the instrument triggers on a rising or falling edge of the signal at the Ext Trig connector, select
the external trigger source before choosing Trigger Setup.
SCPI Command
TRIGger[1|2]:SOURce {IMMediate|EXTernal|TIMer|BUS}
TRIGger[1|2]:SLOPe {POSitive|NEGative}
See Triggering for more information.
If the duty cycle is changed on a triggered bursted square wave with the trigger mode set to Timer, the current burst
will finish and one more burst will be executed before the duty cycle of the burst changes.
Trigger Out Signal
See Trigger Output Signal for more details.
Keysight EDU33210 Series User's Guide
139