Keysight EDU33210 Series - Channel [Setup] and [On; Off] Button

– Enable or disable error beeper
– Enable disable keypad click
– Turn display on and off
– Adjust display dimming behavior
– Set date and time
Help Softkey
Shows list of Help topics:
– View "about" data - serial number, IP address, firmware version, and so on
– View remote command error queue
Channel [Setup] and [On / Off] Button
Enables and configures channels:
[On / Off] button
Turn channel on and off
[Setup] button
Configure channel-related parameters:
– Specify which channel is the focus of the menus
– Select output termination (50 Ω, High Z, or Manual)
– Enable/disable amplitude autoranging
– Select waveform polarity (normal or inverted)
– Specify voltage limits
– Specify whether output is normal or gated
For EDU33212A only
Press [Setup] twice to enter dual channel view mode. In this mode, pressing [Setup] toggles between
single channel view and dual channel view.
78
Keysight EDU33210 Series User's Guide