Keysight EDU33210 Series - Waveform Polarity

SCPI Command
OUTPut[1|2] {ON|1|OFF|0}
The APPLy command always enables the channel output connector.
Waveform Polarity
In normal mode (default), the waveform goes positive at the beginning of the cycle. Inverted mode does the
opposite.
– As shown below, the waveform is inverted relative to the offset voltage. The offset voltage remains unchanged
when the waveform is inverted.
– The Sync signal associated with an inverted waveform is not inverted.
Front Panel Operations
Press [Setup] > Polarity Normal | Inverted or Polarity Normal | Inverted.
92
Keysight EDU33210 Series User's Guide