SCPI Command
[SOURce[1|2]:]FUNCtion:PULSe:PERiod {<seconds>|MINimum|MAXimum|DEFault}
Sum Modulation
Sum modulation adds a modulating signal to any carrier waveform; it is typically used to add Gaussian noise to a
carrier. The modulating signal is added to the carrier as a percentage of carrier waveform amplitude.
Enable Sum
To avoid multiple waveform changes, enable Sum after configuring other modulation parameters.
Front Panel Operations
1. Press [Modulate] > Type AM > Type Sum.
2. Press Modulate ON | OFF > Modulate ON | OFF.
SCPI Command
[SOURce[1|2]:]SUM:STATe {ON|1|OFF|0}
Modulating Waveform Shape
On a two-channel instrument you can modulate one channel with the other.
The modulating waveform shape may be:
– Sine wave
– Square with 50% duty cycle
118
Keysight EDU33210 Series User's Guide
To Next Page
Loading...
