Output a Frequency Sweep
In the frequency sweep mode, the instrument moves from the start frequency to the stop frequency at a sweep rate,
which you specify. You can sweep up or down in frequency, and with either linear or logarithmic spacing, or using a
list of frequencies. For this example, you will output a swept sinewave from 50 Hz to 5 kHz.
1. Select the function and amplitude for the sweep.
For sweeps, you can select sine, square, ramp, pulse, triangle, PRBS waveforms, or arbitrary waveforms (noise and
DC are not allowed). For this example, select a sine wave with an amplitude of 5 Vpp.
62
Keysight EDU33210 Series User's Guide
To Next Page
Loading...
