2. Press Channel [On/Off] to produce the DC output.
SCPI Command
[SOURce[1|2]:]FUNCtion <function>
The APPLy command configures a waveform with one command.
Output Frequency
The output frequency range depends on the function, model, and output voltage, as shown here. The default
frequency is 1 kHz for all functions, and the minimum frequencies are shown in the table below.
Function Minimum Frequency
Sine 1 µHz
Square 1 μHz
Ramp/Triangle 1 μHz
Pulse 1 μHz
PRBS 1 mbps
Arbitrary 1 μSa/s
– Frequency limitations: Changing functions may change the frequency to meet the new function's frequency limits.
Arbitrary waveforms retain their last frequency setting.
– Burst limitation: For internally-triggered bursts, the minimum frequency is 126 μHz.
– Duty cycle limitations: For Square and Pulse, the Duty Cycle is limited by the 16-ns minimum pulse width
specification. For example, at 1 kHz, Duty Cycle may be set as low as 0.01%, because that would result in a pulse
width of 100 ns. At 1 MHz, the minimum Duty Cycle is 1.6%, and at 10 MHz it is 16%. Changing to a frequency that
cannot produce the current duty cycle will adjust the duty cycle to meet the minimum pulse width specification.
The minimum pulse width is 16 ns.
82
Keysight EDU33210 Series User's Guide
To Next Page
Loading...
