EasyManuals Logo

Keysight EDU33210 Series User Manual

Keysight EDU33210 Series
503 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Output Configuration
This section describes the output channel configuration. Many commands associated with the output configuration
starts with SOURce1: or SOURce2: to indicate a certain channel. If omitted, the default is channel 1. For example,
VOLT 2.5 sets the output on channel 1 to 2.5 V, and SOUR2:VOLT2.5 does the same for channel 2.
The instrument's display includes a "tab" for each channel that summarizes various aspects of each channel's output
configuration:
On a dual-channel instrument, the tab for channel 1 is in yellow, and the tab for channel 2 is in green.
Output Function
The instrument includes eight standard waveforms: sine, square, ramp, pulse, triangle, noise, PRBS (pseudorandom
binary sequence), and DC. There are also nine built-in arbitrary waveforms.
The table below shows which functions are allowed (●) with modulation, sweep, and burst. Selecting a function that
is not allowed with a modulation or mode disables the modulation or mode.
Carrier AM FM PM FSK BPSK PWM Sum Burst Sweep
Sine and Square
Pulse
Triangle and Ramp
Gaussian Noise
1
PRBS
Arbitrary Waveform
2
2
1 Gated burst only
80
Keysight EDU33210 Series User's Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight EDU33210 Series and is the answer not in the manual?

Keysight EDU33210 Series Specifications

General IconGeneral
BrandKeysight
ModelEDU33210 Series
CategoryPortable Generator
LanguageEnglish

Related product manuals