Keysight EDU33210 Series - Page 140

Front Panel Operations
1. Press [Burst] > Burst ON | OFF > Burst ON | OFF.
2. Press [Trigger] > Trig Out Setup.
3. Then use this softkey to choose the desired edge direction: Press Trig Out Off | (Up) | (Down).
SCPI Command
OUTPut:TRIGger:SLOPe {POSitive|NEGative}
OUTPut:TRIGger {ON|1|OFF|0}
140
Keysight EDU33210 Series User's Guide