Keysight EDU33210 Series - Page 27

2. Enter the magnitude of the desired amplitude.
Press [Parameters] > Amplitude. Using the numeric keypad, enter the number 50.
3. Select the desired units.
Press the softkey that corresponds to the desired units. When you select the units, the instrument outputs the wave-
form with the displayed amplitude (if the output is enabled). For this example, press mVpp.
You can also enter the desired value using the knob and arrows. If you do so, you do not need to use a units softkey.
You can easily convert unit types. Simply press [Units] > Amplitude and select the desired units.
Keysight EDU33210 Series User's Guide
27