2. Establish an "IP Setup."
If you are not using DHCP (use the Services softkey to set DHCP to OFF), you must establish an IP setup, including
an IP address, and possibly a subnet mask and gateway address.
Press [Back] > Addresses > Modify to configure the IP address, subnet mask, and gateway address.
Contact your network administrator for the IP address, subnet mask, and gateway to use.
IP Address: All IP addresses take the dot-notation form "nnn.nnn.nnn.nnn" where "nnn" in each case is a byte value
in the range 0 through 255. You can enter a new IP address using the numeric keypad (not the knob). Type in the
numbers using the keypad and the cursor keys. Press Previous or Next to move the cursor to the next field or pre-
vious field. Do not enter leading zeros.
44
Keysight EDU33210 Series User's Guide
To Next Page
Loading...
Need help?
General
