Kval 994-X - Page 117

3,000 Cycles
Inspect Inspect feed belts for proper tension or damage.
Inspect Inspect screw drop tubes for kinks, cracks or wear from rubbing. Ensure tube
clamps are tight.
Inspect Inspect all photo eyes secure and tight.
Inspect Inspectalllimitswitcharmsfortightnessorbreaks
Inspect Inspect split shells and screw receivers on six shooters for cracks or breaks.
Replace if broken.
Inspect Inspect all airlines for kinks or rubbing.
Lubricate Refill all lubricators. Replace fluid if milky or discolored. Use ab ISO 32 stan-
dard hydraulic oil (KVAL PN:SYS-LUBEG).
Lubricate Grease ball screw bearings (if applicable).
Clean Clean all bearing shafts with clean, dry cloth.
12,000 Cycles
Inspect Inspect chains for proper tension or damage
Inspect Inspect all air cylinders for air leaks. Replace if seal is leaking
Inspect Inspecthydrauliclinesforloosefittings,leaksandcracks.
Inspect Inspectballrailshaftsforpittingorabrasions.
Lubricate Cleanandlubricateallslidesandcylinderrodswithdrysiliconespray
Lubricate Lubricateallbearingshaftswithsiliconeandcleanrag.
Clean
Clean inside hopper with WD-40 and a 3M Scotchbrite
®
pad. Wipe dry with a
clean dry rag
72,000 Cycles
Inspect Inspect all nuts and bolts for tightnesses Tighten is necessary.
Inspect Checkthatthereisasmoothtransitionwithadoorfeedingintoandoutof
machine.
Back-up Backupcomputersoftware.
Clean Washfilterandlubricatorbowlswithsoapywater.
Maintenance Schedule
5-3
KVAL 994-X Operation/Service Manual