Maintenance NO-GOES
KVAL 994-X Operation/Service Manual
5-16
Maintenance NO-GOES
Do not perform the following. This machine is tuned an calibrated at the factory. If any of these
conditions are changed, timing, accuracy, or damage may occur during the machine process.
• Do not adjust air PSI above or below factory settings
• Do not adjust any and all flow controls from factory settings
• Do not remove shim stock
• Do not Change or Alter any safety assemblies (E-Stops, Gate Locks, etc)
• Do not Change programs in PLC’s or PC’s
• Do not Alter Electrical Components
To Next Page
Loading...
