Kval 994-X - Front Section Calibrations

Check Specifications of the Front Section
3-7
KVAL 994-X Operation/Service Manual
Check Specifications of the Front Section
Follow these steps in this section to verify the result of the cut and, if necessary, adjust the
machine.
Enter a Positive or Negative Number?
Determine when to enter a positive of negative number by using your Left Hand. Use the cut on
the door as a reference. Hold out the left hand with the first finger pointed at the door, second fin-
ger and thumb at right angle to each other. The first finger represents the positive direction of the
‘Z” axis, the thumb represents the positive direction of the ‘Y” axis, then second finger represents
the positive the direction of the ‘X’ axis.
Y-
X Axis Positive
movement
Z Axis Positive
movement
Y Axis Positive
movement
Z -
X +
Y +
Z +
X -
Either Front Section or Back Section Cuts