Back Section:
2-21
KVAL 994-X Operation/Service Manual
Back Section:
• Works in partnership with front section process
• Includes faceplate routing
• Includes boring for lock and bolt.
Front View of Rear Section
Valve Bank: Controls Air
Cylinders on back section
Feed Belt: Feeds Door
through Machine
Lock Bore Motor and Drill:
Drills locks holes on the face
of the door
Ball Catch Motor
and Drill (Opt BC)
Drills ball catch top
edge (Out-Feed)
on LH Door
Ball Catch Motor
and Drill (Opt BC)
Drills ball catch on
top edge (In-Feed)
on RH Door
Chip Out Location
Servo Motor: Lock Sec-
tion
Self Centering ‘X’ Axis:
Centers the Bolt drill in the
‘X’ axis.
Ball Catch Shifts for
6’8'' to 8’0'' Door
To Next Page
Loading...
